Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006OPTRA (CANADA) L4-2.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSFUEL TANK LEAK TEST
2006 Chevrolet Optra (CANADA) L4-2.0L
Fuel Tank Leak Test
2006 Chevrolet Optra (CANADA) L4-2.0LSECTION Fuel Tank Leak Test
Fuel Tank Leak Test
Caution: Place a dry chemical (Class B) fire extinguisher near the area before performing a Fuel Tank Leak Check. Before removing the fuel tank for a suspected leak, make sure that the fuel pipes or the tubes are not leaking onto the tank. Once removed, make sure that the fuel is not leaking around the fuel sender O-ring. Failure to follow these precautions may result in personal injury.
1. Drain the fuel tank. Refer to Fuel Tank Draining Procedure Procedures.
2. Remove the fuel tank. Refer to Fuel Tank Replacement Removal and Replacement.
3. Plug the fuel feed hose, the fuel limiter vent valve hose, and the fuel tank vent valve hose on the fuel tank.
4. Plug the fuel filler neck opening.
5. Connect a piece of the hose to the breather hose nipple on the fuel tank and secure the hose with one clamp.
6. Submerge the fuel tank in water or apply a soapy solution to the outside of the tank.
7. Apply 7-15 kPa (1-2 psi) air pressure to the breather hose.
8. Air bubbles appearing from the fuel tank indicate a leak.
9. Replace the fuel tank if the tank is leaking.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.