Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006OPTRA (CANADA) L4-2.0LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLDISC BRAKE SYSTEMBRAKE ROTOR/DISCSERVICE AND REPAIRBRAKE ROTOR REPLACEMENT - FRONT
2006 Chevrolet Optra (CANADA) L4-2.0L
Brake Rotor Replacement - Front
2006 Chevrolet Optra (CANADA) L4-2.0LSECTION Brake Rotor Replacement - Front
Brake Rotor Replacement - Front
Removal Procedure
Important: To guarantee uniform braking on both sides, both rotors must have identical surfaces regarding smoothness and scoring depth. For this reason, always replace both rotors.
1. Remove the caliper assembly without disconnecting the brake hoses. Refer to Brake Caliper Replacement - Front Brake Caliper Replacement - Front.
2. Remove the rotor-to-front wheel hub detent screws.
3. Pull off the rotor.
Installation Procedure
1. Inspect the rotor. Refer to Brake Rotor Surface and Wear Inspection Testing and Inspection.
Notice: Refer to Fastener Notice Fastener Notice in Cautions and Notices.
2. Install the rotor to the front wheel hub by tightening the detent screw.
Tighten the rotor-to-front wheel hub detent screw to 4 Nm (35 lb in).
3. Install the caliper assembly. Refer to Brake Caliper Replacement - Front Brake Caliper Replacement - Front
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.