Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006MONTE CARLO V8-5.3L VIN CREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESHIFT INTERLOCKTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESSCAN TOOL DATA DEFINITIONS
2006 Chevrolet Monte Carlo V8-5.3L VIN C
Scan Tool Data Definitions
2006 Chevrolet Monte Carlo V8-5.3L VIN CSECTION Scan Tool Data Definitions
Scan Tool Data Definitions
Body Control Module (BCM)
Battery Voltage
Display indicates battery voltage. Measured in volts.
Shift Lock Solenoid Command
Displays indicates ACTIVE when the brake switch is depressed on Floor Shift.
Shift Lock Solenoid Command:
Displays indicate INACTIVE when the brake switch is depressed on Column Shift.
Ignition 1 Signal
Display indicates ON when the ignition 1 input circuit of the module receives a battery signal from the ignition switch.
Remote Start
Display indicates the current status of the remote start request.
Engine Control Module (ECM)
Current Gear
Displays current gear position of the transmission
TCC Brake Switch
Displays ON or OFF status of the TCC Brake switch.
TR Sw. A/B/C/P
Displays LOW or HI for the state of each of the four inputs from the IMS. LOW displayed indicates a low voltage signal (0 volts) being monitored at the ECM. HI displayed indicates a high voltage signal (B+) being monitored at the ECM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.