Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006MONTE CARLO V6-3.9L VIN 1REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYPISTON RING, ENGINE
2006 Chevrolet Monte Carlo V6-3.9L VIN 1
Piston Ring, Engine
2006 Chevrolet Monte Carlo V6-3.9L VIN 1SECTION Piston Ring, Engine
Piston Ring End Gap
First Compression Ring 0.15 - 0.30 mm (0.006 - 0.011 inch)
Second Compression Ring 0.25 - 0.45 mm (0.009 - 0.017 inch)
Oil Control Ring 0.15 - 0.65 mm (0.06 - 0.025 inch)
Piston Ring to Groove Clearance
First Compression Ring 0.03 - 0.065 mm (0.001 - 0.002 inch)
Second Compression Ring 0.02 - 0.055 mm (0.0007 - 0.002 inch)
Oil Control Ring 0.01 mm (0.004 inch)
Piston Ring Thickness
First Compression Ring 1.175 - 1.190 mm (0.046 - 0.047 inch)
Second Compression Ring 1.475 - 1.490 mm (0.058 inch)
Oil Control Ring - Maximum 2.50 mm (0.098 inch)
First Compression Ring 0.15 - 0.30 mm (0.006 - 0.011 inch)
Second Compression Ring 0.25 - 0.45 mm (0.009 - 0.017 inch)
Oil Control Ring 0.15 - 0.65 mm (0.06 - 0.025 inch)
Piston Ring to Groove Clearance
First Compression Ring 0.03 - 0.065 mm (0.001 - 0.002 inch)
Second Compression Ring 0.02 - 0.055 mm (0.0007 - 0.002 inch)
Oil Control Ring 0.01 mm (0.004 inch)
Piston Ring Thickness
First Compression Ring 1.175 - 1.190 mm (0.046 - 0.047 inch)
Second Compression Ring 1.475 - 1.490 mm (0.058 inch)
Oil Control Ring - Maximum 2.50 mm (0.098 inch)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.