Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006MONTE CARLO V6-3.9L VIN 1REPAIR AND DIAGNOSISSPECIFICATIONSCAPACITY SPECIFICATIONSREFRIGERANT OIL
2006 Chevrolet Monte Carlo V6-3.9L VIN 1
Refrigerant Oil
2006 Chevrolet Monte Carlo V6-3.9L VIN 1SECTION Refrigerant Oil
REFRIGERANT SYSTEM CAPACITIES
ABRUPT REFRIGERANT LOSS 60 ml (2.0 ounces)
NOTE: Abrupt refrigerant loss due to large leak, hose rupture, collision, or pressure relief valve opening. Conditions that allow the refrigerant to seep or bleed off over time do not cause this oil loss. Upon replacement of a component that caused a large refrigerant loss, also add the required amount of oil for the particular component.
COMPRESSOR REPLACEMENT
The 7CVC service compressor is shipped with 150 ml (5 ounces)
NOTE: If more than the specified amount of PAG oil was drained from a component, add the amount drained.
IMPORTANT: Compressor failure can occur if the oil removed during refrigerant recovery is not replaced.
CONDENSER REPLACEMENT 30 ml (1.0 ounces)
NOTE: If more than the specified amount of PAG oil was drained from a component, add the amount drained.
EVAPORATOR REPLACEMENT 90 ml (3.0 ounces)
NOTE: If more than the specified amount of PAG oil was drained from a component, add the amount drained.
ANY LINE SET (HOSE/TUBE OR TUBE ASSEMBLY) REPLACEMENT 30 ml (1.0 ounces)
NOTE: If more than the specified amount of PAG oil was drained from a component, add the amount drained.
NOTE: Abrupt refrigerant loss due to large leak, hose rupture, collision, or pressure relief valve opening. Conditions that allow the refrigerant to seep or bleed off over time do not cause this oil loss. Upon replacement of a component that caused a large refrigerant loss, also add the required amount of oil for the particular component.
TOTAL SYSTEM PAG OIL CAPACITY 150.0 ml (5 ounces)
NOTE: All capacities are approximate.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.