Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006MONTE CARLO V6-3.9L VIN 1REPAIR AND DIAGNOSISMAINTENANCEWHEELS AND TIRESTIRE MONITORING SYSTEMTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESSCAN TOOL DATA DEFINITIONS
2006 Chevrolet Monte Carlo V6-3.9L VIN 1
Scan Tool Data Definitions
2006 Chevrolet Monte Carlo V6-3.9L VIN 1SECTION Scan Tool Data Definitions
Scan Tool Data Definitions
Battery Voltage
The scan tool displays 8-14 volts. The amount of battery voltage available at the body control module (BCM).
LF, LR, RF, RR Pressure Sensor ID
The scan tool displays a number up to 8 digits in length, or an asterisk. A number displayed indicates the tire pressure sensor unique identification (Id) code, and that it has been learned into the BCMs memory. An asterisk indicates the sensors Id code has not been learned into the PDMs memory.
LF, LR, RF, RR Pressure Sensor Mode
Stationary indicates the sensors internal roll switch is open and the sensor has made its stationary transmission which occurs once every 60 minutes from the last stationary transmission. Wake indicates the sensor is transitioning to drive mode, in this mode the sensor has detected an initial roll switch closure. Drive indicates the sensors roll switch has been closed for at least 10 seconds and the sensor is transmitting once every 60 seconds. Re-Measure indicates the sensor has detected a 1.6 psi change in tire pressure. Learn indicates the sensor has been activated by a low frequency transmission. Low Bat indicates the sensor's internal battery charge level is low. N/A indicates the sensor is in a mode not supported by the scan tool.
LF, LR, RF, RR Tire Pressure
The scan tool displays 0-344 kPa (0-51 psi). The actual pressure of the left front tire.
Sensor Learn Mode
The scan tool displays Active, or Inactive. Active indicates the Tire Pressure Monitor (TPM) systems tire pressure sensor learn mode is active and able to learn all 4 sensor Id codes. Inactive indicates the TPM system is not able to learn the sensor Id codes.
Selected Front Tire Pressure
The scan tool displays the front tire pressure that was last selected for the vehicle.
Selected Rear Tire Pressure
The scan tool displays the rear tire pressure that was last selected for the vehicle
Selected Tire Type
The scan tool displays P-Metric Standard, P-Metric Extended, Load Range C, Load Range D, Load Range E. The tire type that was last selected for the vehicle.
TPM System Enabled
The scan tool displays Yes, or No. Yes indicates the TPM option has been enabled in the PDM. No indicates the TPM option has not been enabled in the PDM.
Vehicle Speed
The scan tool displays 0-255 km/h (0-159 mph). The actual speed of the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.