Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006MONTE CARLO V6-3.5L VIN NREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULETESTING AND INSPECTIONPROGRAMMING AND RELEARNINGBODY CONTROL MODULE PROGRAMMING AND SETUP
2006 Chevrolet Monte Carlo V6-3.5L VIN N
Body Control Module Programming and Setup
2006 Chevrolet Monte Carlo V6-3.5L VIN NSECTION Body Control Module Programming and Setup
BODY CONTROL MODULE PROGRAMMING AND SETUP
BODY CONTROL MODULE (BCM) REPLACEMENT
IMPORTANT: The vehicle will not start and many other functions may not operate properly if a replacement body control module (BCM) is not properly set up. The following procedures must be performed in the following order:
1. BCM Reprogramming-Refer to Body Control Module (BCM) Programming/RPO Configuration.
2. Learning the restraints ID-Refer to Body Control Module (BCM) Programming/RPO Configuration.
3. BPP Sensor calibration-Refer to Body Control Module (BCM) Programming/RPO Configuration.
BCM REPROGRAMMING
If the BCM is reprogrammed, the following procedures must be performed
1. BCM Reprogramming-Refer to Body Control Module (BCM) Programming/RPO Configuration.
2. Learning the restraints ID-Refer to Body Control Module (BCM) Programming/RPO Configuration.
3. BPP Sensor calibration-Refer to Body Control Module (BCM) Programming/RPO Configuration.
INFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE (SDM) REPLACEMENT
If the sensing and diagnostic module (SDM) is replaced, learning the restraints ID procedure needs to be performed. Refer to Body Control Module (BCM) Programming/RPO Configuration.
BPP SENSOR REPLACEMENT
If the brake pedal position (BPP) sensor is replaced, BPP sensor calibration procedure needs to be performed. Refer to Body Control Module (BCM) Programming/RPO Configuration.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.