Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006MALIBU V6-3.9L VIN 1REPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIRACCESSORY SWITCH REPLACEMENT
2006 Chevrolet Malibu V6-3.9L VIN 1
Accessory Switch Replacement
2006 Chevrolet Malibu V6-3.9L VIN 1SECTION Accessory Switch Replacement
ACCESSORY SWITCH REPLACEMENT
REMOVAL PROCEDURE
1. Remove the left instrument panel (I/P) trim panel.
2. Remove the fog lamp switch wire harness connector.
3. Remove the fog lamp switch.
4. Remove the adjustable pedal switch wire harness connector.
5. Remove the adjustable pedal switch.
INSTALLATION PROCEDURE
1. Install the adjustable pedal switch.
2. Install the adjustable pedal switch wire harness connector.
3. Install the fog lamp switch.
4. Install the fog lamp switch wire harness connector.
5. Install the left I/P trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.