Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006MALIBU V6-3.9L VIN 1REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BODY AND FRAMESEAT TEMPERATURE CONTROL MODULESERVICE AND REPAIRPROCEDURES
2006 Chevrolet Malibu V6-3.9L VIN 1
Procedures
2006 Chevrolet Malibu V6-3.9L VIN 1SECTION Procedures
HEATED SEAT CONTROL MODULE REPLACEMENT - FRONT
REMOVAL PROCEDURE
1. Remove the front seat.
CAUTION: Refer to SIR Caution.
2. Disconnect the electrical connection from the heated seat control module.
3. Remove the fastener from the heated seat control module.
4. Remove the heated seat control module.
INSTALLATION PROCEDURE
1. Install the heated seat control module.
2. Install the fastener to the heated seat control module.
3. Connect the electrical connection to the heated seat control module.
4. Install the front seat.
5. Verify that the heated seat works correctly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.