Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006MALIBU V6-3.9L VIN 1REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSACCELERATOR PEDAL POSITION SENSORSERVICE AND REPAIR
2006 Chevrolet Malibu V6-3.9L VIN 1
Accelerator Pedal Position Sensor: Service and Repair
2006 Chevrolet Malibu V6-3.9L VIN 1SECTION Service and Repair
ACCELERATOR PEDAL WITH POSITION SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the accelerator pedal position (APP) sensor electrical connector.
2. Remove the APP sensor bolts (1).
3. Remove the APP sensor (2).
INSTALLATION PROCEDURE
1. Install the APP sensor (2).
2. Install the APP bolts (1).
NOTE: Refer to Fastener Notice.
Tighten the bolts to 10 N.m (89 lb in).
3. Connect the APP sensor electrical connector.
4. Confirm that the APP sensor connector locking clip is fully secured.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.