SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006MALIBU V6-3.9L VIN 1REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERKEYLESS ENTRY TRANSMITTER BATTERYSERVICE AND REPAIR
2006 Chevrolet Malibu V6-3.9L VIN 1

Keyless Entry Transmitter Battery: Service and Repair

2006 Chevrolet Malibu V6-3.9L VIN 1SECTION Service and Repair


TRANSMITTER BATTERY REPLACEMENT

REMOVAL PROCEDURE




1. Insert a flat object, with a thin edge, into the notch located below the remote alarm button and separate the bottom half from the top half of the transmitter.

NOTE: When replacing the battery, use care not to touch any of the circuitry. Static from your body transferred to these surfaces may damage the transmitter.

2. Remove the battery from the transmitter.

INSTALLATION PROCEDURE




1. Install the battery into the transmitter with the positive side of the battery facing up. Use a type CR2032 battery, or equivalent.
2. Snap the front and back half of the transmitter together.
3. Ensure the transmitter halves are tight to prevent moisture from intruding into the transmitter.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.