Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006MALIBU V6-3.9L VIN 1REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY RECEIVERSERVICE AND REPAIRREMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT (EXTENDED SEDAN)
2006 Chevrolet Malibu V6-3.9L VIN 1
Remote Control Door Lock Receiver Replacement (Extended Sedan)
2006 Chevrolet Malibu V6-3.9L VIN 1SECTION Remote Control Door Lock Receiver Replacement (Extended Sedan)
REMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT (EXTENDED SEDAN)
REMOVAL PROCEDURE
1. Remove the rear quarter lower trim panel.
2. Disconnect the electrical connectors from the receiver.
3. Remove the receiver from the vehicle.
INSTALLATION PROCEDURE
1. Install the receiver to the vehicle.
2. Connect the electrical connectors to the receiver.
3. Install the rear quarter lower trim panel.
4. The transmitter will need to be programmed after replacement. Refer to Transmitter Programming.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.