Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006MALIBU V6-3.9L VIN 1REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTANTITHEFT AND ALARM SYSTEMSALARM MODULESERVICE AND REPAIR
2006 Chevrolet Malibu V6-3.9L VIN 1
Alarm Module: Service and Repair
2006 Chevrolet Malibu V6-3.9L VIN 1SECTION Service and Repair
THEFT DETERRENT CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the ignition switch.
2. Remove the theft deterrent control module screws.
3. Remove the theft deterrent control module.
INSTALLATION PROCEDURE
1. Install the theft deterrent control module.
2. Tighten the theft deterrent control module screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 5 N.m (44 lb in).
3. Install the ignition switch.
4. Program the theft deterrent control module after replacement. Refer to Control Module References.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.