Scan Tool Data Definitions

2006 Chevrolet Malibu V6-3.5L VIN 8SECTION Scan Tool Data Definitions


SCAN TOOL DATA DEFINITIONS

Battery Voltage Signal: The scan tool displays 0.0-16.0 volts. The battery voltage input represents the system voltage measured at the module ignition feed input.

Windshield Wiper Switch: The scan tool displays the set position of the Windshield Wiper Switch.

Wiper Park Switch: The scan tool displays if wipers are in the park position or not. If the scan tool displays Off the wipers are in the parked position.

Windshield Washer Switch: The scan tool displays the position of the wash switch.

Wiper Motor Delay Time: The scan tool displays the Intermittent delay time in seconds. Time periods are between 0-25 seconds.

Wiper Motor Relay Command: The scan tool displays if the BCM is commanding the wiper 1 relay On or Off.

Wiper Motor Relay Status: The scan tool displays the status of the wiper 1 relay.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.