Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006IMPALA V6-3.5L VIN K FLEX FUELREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSBATTERY CURRENT SENSORSERVICE AND REPAIR
2006 Chevrolet Impala V6-3.5L VIN K Flex Fuel
Battery Current Sensor: Service and Repair
2006 Chevrolet Impala V6-3.5L VIN K Flex FuelSECTION Service and Repair
BATTERY CURRENT SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the instrument panel (I/P) harness electrical connector (1) from the battery current sensor.
2. Remove the positive and negative battery cable.
3. Cut the tie straps and electrical tape attaching the battery current sensor to the positive battery cable.
4. Squeeze the positive and negative battery cable branches together.
5. Slide the battery current sensor (1) off of the battery cable.
IMPORTANT: Note the position of the battery current sensor prior to removal.
INSTALLATION PROCEDURE
1. Slide the NEW battery current sensor (1) up onto the battery cable.
IMPORTANT: Ensure that the tape tab is pointing towards the positive battery terminal prior to installation.
2. Using NEW tie straps and electrical tape, attach the battery current sensor to the positive battery cable.
3. Install the positive and negative battery cable.
4. Connect the I/P harness electrical connector (1) to the battery current sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.