Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006HHR L4-2.4LREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING COLUMNSERVICE AND REPAIRMULTIFUNCTION, TURN SIGNAL SWITCH REPLACEMENT
2006 Chevrolet HHR L4-2.4L
Multifunction, Turn Signal Switch Replacement
2006 Chevrolet HHR L4-2.4LSECTION Multifunction, Turn Signal Switch Replacement
Multifunction, Turn Signal Switch Replacement
Removal Procedure
1. Remove the steering column trim covers.
2. Disconnect the multifunction turn signal switch harness connector.
3. Depress the locking tabs and remove the multifunction turn signal switch from the steering column.
Installation Procedure
1. Install the multifunction turn signal switch to the steering column. Ensure the locking tabs are snapped into place.
2. Connect the multifunction turn signal switch harness connector.
3. Install the steering column trim covers.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.