Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006HHR L4-2.4LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINETIMING COMPONENTSSPECIFICATIONS
2006 Chevrolet HHR L4-2.4L
Timing Components: Specifications
2006 Chevrolet HHR L4-2.4LSECTION Specifications
Crankshaft Balancer Bolt
First Pass 100 Nm (74 ft. lbs.)
Final Pass 125 degrees
Front Cover to Block Bolt 25 Nm (18 ft. lbs.)
First Pass 100 Nm (74 ft. lbs.)
Final Pass 125 degrees
Front Cover to Block Bolt 25 Nm (18 ft. lbs.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.