Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006HHR L4-2.4LREPAIR AND DIAGNOSISCRUISE CONTROLTESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESCRUISE CONTROL INOPERATIVE/MALFUNCTIONING
2006 Chevrolet HHR L4-2.4L
Cruise Control Inoperative/Malfunctioning
2006 Chevrolet HHR L4-2.4LSECTION Cruise Control Inoperative/Malfunctioning
CRUISE CONTROL INOPERATIVE/MALFUNCTIONING
DIAGNOSTIC AIDS
CAUTION: Refer to SIR Caution. Disable the inflatable restraint steering wheel module when performing this diagnostic table. Refer to SIR Disabling and Enabling Zone 3.
- Ensure that the following cruise control switches are not stuck in the engaged position:
- On/off switch
- - SET switch
- + RES switch
- With a scan tool, observe the associated cruise control switch parameter in the Body and Accessories, Cruise Control, BCM data list, while rotating the steering wheel to both steering stops and separately activating each cruise control switch. This will help eliminate the possibility of an internally shorted inflatable restraint steering wheel module coil.
- For an intermittent condition, refer to Testing for Intermittent Conditions and Poor Connections. Component Tests and General Diagnostics
TEST
Step 1 - Step 8:
Step 9 - Step 15:
Step 16 - Step 22:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.