Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006HHR L4-2.2LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLETORQUE CONVERTERSERVICE AND REPAIR
2006 Chevrolet HHR L4-2.2L
Torque Converter: Service and Repair
2006 Chevrolet HHR L4-2.2LSECTION Service and Repair
Torque Converter, Turbine Shaft Seal Replacement
Removal Procedure
1. Caution:
Refer to Battery Disconnect Caution in Service Precautions.
Disconnect the negative battery cable.
2. Remove the transmission assembly from the vehicle. Refer to Transmission Replacement.
3. Remove the torque convertor assembly from the transmission.
4. Remove the torque convertor O-ring seal from the end of the turbine shaft. Use a screwdriver.
Installation Procedure
1. Install a new torque convertor O-ring seal on the end of the turbine shaft.
2. Install the torque convertor onto the transmission.
3. Install the transmission into the vehicle.
4. Connect the negative battery cable.
5. Adjust the transmission oil level. Refer to Transmission Fluid Checking Procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.