Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006HHR L4-2.2LREPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONSERVICE AND REPAIRRELAY REPLACEMENT (WITHIN AN ELECTRICAL CENTER)
2006 Chevrolet HHR L4-2.2L
Relay Replacement (Within an Electrical Center)
2006 Chevrolet HHR L4-2.2LSECTION Relay Replacement (Within an Electrical Center)
RELAY REPLACEMENT (WITHIN AN ELECTRICAL CENTER)
TOOLS REQUIRED
J 43244 Relay Puller Pliers
REMOVAL PROCEDURE
1. Remove the electrical center cover.
2. Locate the relay.
3. Using the J 43244 (1) position the tool on opposing corners of the relay (2).
IMPORTANT:
- Always note the orientation of the relay.
- Ensure that the electrical center is secure, as not to put added stress on the wires or terminals.
4. Remove the relay (2) from the electrical center.
NOTE: Use J43244 to pull the relay straight out from the electrical center terminals. The use of pliers or a flat bladed tool could damage the electrical center.
INSTALLATION PROCEDURE
1. Install the relay (2) in the same position as removed.
2. Install the electrical center cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.