Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006HHR L4-2.2LREPAIR AND DIAGNOSISLIGHTING AND HORNSBRAKE LIGHT SWITCHSERVICE AND REPAIR
2006 Chevrolet HHR L4-2.2L
Brake Light Switch: Service and Repair
2006 Chevrolet HHR L4-2.2LSECTION Service and Repair
STOP LAMP SWITCH REPLACEMENT
REMOVAL PROCEDURE
1. Remove the left side of the instrument panel (I/P) insulator.
2. Disconnect the electrical connector from the stop lamp switch.
3. Remove the stop lamp switch (2) from the brake pedal bracket.
INSTALLATION PROCEDURE
1. Install the stop lamp switch (2) to the brake pedal bracket.
2. Connect the electrical connector to the stop lamp switch.
3. Install the left side of the I/P insulator.
4. Adjust the stop lamp switch. Refer to Stop Lamp Switch Adjustment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.