Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006HHR L4-2.2LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINECYLINDER BLOCK ASSEMBLYENGINE BLOCK HEATERSERVICE AND REPAIRCOOLANT HEATER REPLACEMENT
2006 Chevrolet HHR L4-2.2L
Coolant Heater Replacement
2006 Chevrolet HHR L4-2.2LSECTION Coolant Heater Replacement
Coolant Heater Replacement
Removal Procedure
1. Disconnect the coolant heater cord.
2. Remove the coolant heater bolt.
3. Remove the coolant heater.
Installation Procedure
1. Install the coolant heater.
2. Notice: Refer to Fastener Notice.
Install the coolant heater bolt.
Tighten the bolt to 10 Nm (89 inch lbs.).
3. Connect the coolant heater cord.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.