Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006HHR L4-2.2LREPAIR AND DIAGNOSISBODY AND FRAMEMIRRORSSERVICE AND REPAIRPROCEDURESREARVIEW MIRROR REPLACEMENT
2006 Chevrolet HHR L4-2.2L
Rearview Mirror Replacement
2006 Chevrolet HHR L4-2.2LSECTION Rearview Mirror Replacement
REARVIEW MIRROR REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the electrical connector (3) from the back of the mirror.
2. Remove the wire harness cover.
3. Adjust the mirror to the full upward position.
4. Remove the base trim cover.
5. Loosen the screw at the base in order to remove the mirror from the button.
6. Slide the mirror in an upward motion in order to remove.
INSTALLATION PROCEDURE
1. Position the center bottom of the mirror mount against the windshield at the top of the support button.
2. Slide the base of the mirror onto the button.
3. Make sure the mirror is firmly seated on the windshield button by pushing down on the base of the mirror.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screw (3) to 1.8 N.m (16 lb in) in order to secure the mirror base to the button.
4. Install the base trim cover.
5. Connect the electrical connector (3) to the back of the mirror.
6. Install the wire harness cover.
7. Reposition the mirror.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.