Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006HHR L4-2.2LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYTESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESKEYLESS ENTRY SYSTEM INOPERATIVE
2006 Chevrolet HHR L4-2.2L
Keyless Entry System Inoperative
2006 Chevrolet HHR L4-2.2LSECTION Keyless Entry System Inoperative
KEYLESS ENTRY SYSTEM INOPERATIVE
TEST DESCRIPTION
Step 1 - Step 10:
Step 11 - Step 20:
Step 21 - Step 23:
The number below refers to the step number on the diagnostic table.
14. B+ voltage should be present on the serial data terminal when tested with a DMM, but should not illuminate the test lamp. An illuminated test lamp indicates a short to voltage in the serial data circuit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.