Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006EXPRESS 2500 V8-6.6L DSL TURBO VIN 2REPAIR AND DIAGNOSISSTARTING AND CHARGINGCHARGING SYSTEMALTERNATORSERVICE AND REPAIRGENERATOR BRACKET REPLACEMENT
2006 Chevrolet Express 2500 V8-6.6L DSL Turbo VIN 2
Generator Bracket Replacement
2006 Chevrolet Express 2500 V8-6.6L DSL Turbo VIN 2SECTION Generator Bracket Replacement
GENERATOR BRACKET REPLACEMENT
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution.
1. Disconnect the negative battery cable.
2. Remove the air cleaner assembly.
3. Remove the upper radiator fan shroud.
4. Disconnect the auxiliary generator electrical connector (3).
5. Remove the drive belt.
6. Remove the positive cable from the auxiliary generator, perform the following:
1. Slide the boot (4) down to access the terminal stud.
2. Remove the positive cable nut (1).
3. Remove the positive cable.
7. Remove the auxiliary generator bolts (3).
8. Remove the auxiliary generator (4).
9. Remove the auxiliary generator bracket bolt.
10. Remove the auxiliary generator bracket.
INSTALLATION PROCEDURE
1. Install the auxiliary generator bracket.
2. Install the auxiliary generator bracket bolt.
Tighten the bolt to 50 N.m (37 lb ft).
NOTE: Refer to Fastener Notice.
3. Install the auxiliary generator (4).
4. Install the auxiliary generator bolts (3).
Tighten the bolt to 50 N.m (37 lb ft).
5. Install the positive cable to the auxiliary generator, perform the following:
1. Install the positive cable.
2. Install the positive cable nut (1).
Tighten the nut to 9 N.m (80 lb in).
3. Slide the boot (4) up to cover the terminal stud.
6. Install the drive belt.
7. Connect the auxiliary generator electrical connector (3).
8. Install the radiator fan shroud.
9. Install the air cleaner assembly.
10. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.