Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006EXPRESS 2500 V8-6.6L DSL TURBO VIN 2REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULEDIAGRAMSDIAGNOSTIC AIDSGENERAL ELECTRICAL DIAGNOSTIC PROCEDURESCIRCUIT TESTINGTROUBLESHOOTING WITH A TEST LAMP
2006 Chevrolet Express 2500 V8-6.6L DSL Turbo VIN 2
Troubleshooting With A Test Lamp
2006 Chevrolet Express 2500 V8-6.6L DSL Turbo VIN 2SECTION Troubleshooting With A Test Lamp
TROUBLESHOOTING WITH A TEST LAMP
TOOLS REQUIRED
J 35616-200 Test Light - Probe Kit
Note: Refer to Test Probe Notice in Service Precautions.
A test lamp can simply and quickly test a low impedance circuit for voltage.
The J 35616-200 is Micro-Pack compatible and comprised of a 12-volt light bulb with an attached pair of leads.
To properly operate this tool use the following procedures.
When testing for voltage:
1. Attach 1 lead to ground.
2. Touch the other lead to various points along the circuit where voltage should be present.
3. When the bulb illuminates, there is voltage at the point being tested.
When testing for ground:
1. Attach 1 lead to battery positive voltage.
2. Touch the other lead to various points along the circuit where ground should be present.
3. When the bulb illuminates, there is ground at the point being tested.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.