Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006EQUINOX FWD V6-3.4L VIN FREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESSCAN TOOL DATA DEFINITIONS
2006 Chevrolet Equinox FWD V6-3.4L VIN F
Scan Tool Data Definitions
2006 Chevrolet Equinox FWD V6-3.4L VIN FSECTION Scan Tool Data Definitions
SCAN TOOL DATA DEFINITIONS
Front Washer Motor Input: The scan tool displays On/Off. This input displays On when the front washer spray is on.
Front Wiper Relay Cmd.: The scan tool displays On/Off. The body control module will indicate if it is commanding the front wiper relay On or Off.
Front Wiper Relay Fdbk.: The scan tool displays High/Low. This input to the BCM displays the state of the front wiper relay feedback circuit. Low is displayed when the BCM is providing a ground to the front wiper relay control circuit.
Front Wiper Switch: The scan tool displays On/Off. This input displays On when the front wipers are on.
Rear Washer Motor Input: The scan tool displays On/Off. This input displays On when the rear washer spray is on.
Rear Wiper Relay Cmd.:The scan tool displays On/Off. The body control module will indicate if it is commanding the rear wiper relay On or Off.
Rear Wiper Relay Fdbk.: The scan tool displays High/Low. This input to the BCM displays the state of the rear wiper relay feedback circuit. Low is displayed when the BCM is providing a ground to the rear wiper relay control circuit.
Rear Wiper Switch: The scan tool displays On/Off. This input displays On when the rear wipers are on.
Wiper Delay 1: The scan tool displays Yes/No. This input to the body control module displays the state of the wiper delay switch.
Wiper Delay 2: The scan tool displays Yes/No. This input to the body control module displays the state of the wiper delay switch.
Wiper Delay 3: The scan tool displays Yes/No. This input to the body control module displays the state of the wiper delay switch.
Wiper Delay Input: The scan tool displays volts. This input displays the voltage supplied to the body control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.