Control Module: Service and Repair

2006 Chevrolet Equinox FWD V6-3.4L VIN FSECTION Service and Repair


Transaxle Control Module Replacement

Removal Procedure
1. Disconnect the negative battery cable.





2. Remove the TCM from TCM bracket.





3. Disconnect the transaxle control module (TCM) electrical connectors (1) from the TCM (2).

Installation Procedure





1. Connect the TCM electrical connector (1) to the TCM (2).





2. Install the TCM to the TCM bracket.
3. Connect the negative battery cable.

Important: DTC P0602 is set with all new service transaxle control modules. When the transaxle control module is reprogrammed with the correct software and calibrations, DTC P0602 will be erased.

4. Reprogram the TCM with the correct calibration. Refer to Transmission Control Module Programming and Setup.
5. Perform the transmission adaptive learn procedure. Refer to Transmission Adaptive Learn Procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.