Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006EQUINOX FWD V6-3.4L VIN FREPAIR AND DIAGNOSISTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGPOWER STEERING CONTROL MODULE PROGRAMMING AND SETUP
2006 Chevrolet Equinox FWD V6-3.4L VIN F
Power Steering Control Module Programming and Setup
2006 Chevrolet Equinox FWD V6-3.4L VIN FSECTION Power Steering Control Module Programming and Setup
POWER STEERING CONTROL MODULE PROGRAMMING AND SETUP
If the steering column is replaced, the power steering control module (PSCM) must be setup using the scan tool. There are 8 different tuning profile calibrations stored in the PSCM. The scan tool will select the correct tuning profile calibration for this vehicle, and setup the PSCM to use that profile. If the PSCM has not been setup, the scan tool will display the Tuning Profile is 0 in the EPS data list, and DTC C0551 will set.
1. Select F2: Special Functions with the scan tool.
2. Select F0: Steering Tuning Selection.
3. Set the correct Tuning Profile.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.