Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006EQUINOX FWD V6-3.4L VIN FREPAIR AND DIAGNOSISSTARTING AND CHARGINGTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESSCAN TOOL DATA DEFINITIONS
2006 Chevrolet Equinox FWD V6-3.4L VIN F
Scan Tool Data Definitions
2006 Chevrolet Equinox FWD V6-3.4L VIN FSECTION Scan Tool Data Definitions
SCAN TOOL DATA DEFINITIONS
Battery 1: The scan tool displays 0-20 Volts. The scan tool displays the voltage as received on the battery positive voltage circuit of the body control module (BCM).
Crank Request Signal: The scan tool displays Yes/No. The scan tool displays Yes when the powertrain control module (PCM) receives a crank request.
Generator L-Terminal Signal Command: The scan tool displays On/Off. The scan tool displays Off until the engine is running, then the PCM supplies then the percentage value varies depending on electrical loads
Ignition 1 Signal: The scan tool displays 0-20 Volts. The scan tool displays the voltage as received on the Ignition 1 circuit to the PCM.
Starter Relay Command: The scan tool displays On/Off. The scan tool displays Off until the PCM commands the starter relay On.
TR Sw.: The scan tool displays Invalid, Neutral, Drive, Park, Low, Reverse and Intermediate. The scan tool displays the position of the transaxle switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.