Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006EQUINOX FWD V6-3.4L VIN FREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - IGNITION SYSTEMIGNITION CONTROL MODULESERVICE AND REPAIRIGNITION COIL/CONTROL MODULE REPLACEMENT
2006 Chevrolet Equinox FWD V6-3.4L VIN F
Ignition Coil/Control Module Replacement
2006 Chevrolet Equinox FWD V6-3.4L VIN FSECTION Ignition Coil/Control Module Replacement
IGNITION COIL/CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the injector sight shield.
2. Disconnect the spark plug wires. Note the position from which the wires are removed.
3. Disconnect the ignition coil/control module electrical connectors.
4. Remove the 4 bolts securing the ignition coil/control module to the ignition control module bracket.
5. Remove the ignition coil/control module.
INSTALLATION PROCEDURE
1. Install the ignition coil/control module to the ignition control module bracket.
2. Install the 4 bolts securing the ignition coil/control module to the ignition control module bracket.
Tighten the bolts to 4.5 N.m (40 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the ignition coil/control module electrical connectors.
4. Connect the spark plug wires.
5. Install the injector sight shield.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.