Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006EQUINOX FWD V6-3.4L VIN FREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMRELAYS AND MODULES - IGNITION SYSTEMIGNITION CONTROL MODULESERVICE AND REPAIRIGNITION CONTROL MODULE BRACKET
2006 Chevrolet Equinox FWD V6-3.4L VIN F
Ignition Control Module Bracket
2006 Chevrolet Equinox FWD V6-3.4L VIN FSECTION Ignition Control Module Bracket
IGNITION CONTROL MODULE BRACKET REPLACEMENT
REMOVAL PROCEDURE
1. Remove the injector sight shield.
2. Disconnect the ignition coil/control module electrical connectors.
3. Remove the spark plug wire retainer (1) from the ignition control module bracket.
4. Remove the 4 bolts securing the ignition coil/control module to the ignition control module bracket.
5. Position the ignition coil/control module aside out of the way.
6. Remove the bolt (3) from the fuel injector wire harness bracket (4) and positive crankcase ventilation (PCV) valve fresh air tube retainer.
7. Remove the engine wire harness retainers from the ignition control module bracket studs (5).
8. Remove the nut (1) retaining the heater outlet pipe.
9. Lift pipe up slightly to gain access for the removal of the 2 ignition control module bracket bolts.
10. Remove the ignition control module bracket bolts (2).
11. Remove the ignition control module bracket nuts (6).
12. Remove the ignition control module bracket.
INSTALLATION PROCEDURE
1. Install the ignition control module bracket.
2. Install the ignition control module bracket nuts (6).
Tighten the nuts to 25 N.m (18 lb ft).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the ignition control module bracket bolts (2).
Tighten the bolts to 25 N.m (18 lb ft).
4. Install the nut (1) retaining the heater outlet pipe.
Tighten the nut to 25 N.m (18 lb ft).
5. Install the engine wire harness retainers to the ignition control module bracket studs (5).
6. Install the bolt (3) from the fuel injector wire harness bracket (4) and PCV valve fresh air tube retainer.
Tighten the bolts to 5 N.m (44 lb in).
7. Install the ignition coil/control module to the ignition control module bracket.
8. Install the 4 bolts securing the ignition coil/control module to the ignition control module bracket.
Tighten the bolts to 4.5 N.m (40 lb in).
9. Install the spark plug wire retainer (1) to the ignition control module bracket.
10. Connect the ignition coil/control module electrical connectors.
11. Install the injector sight shield.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.