SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006EQUINOX FWD V6-3.4L VIN FREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTRANSMISSION POSITION SENSOR/SWITCHSERVICE AND REPAIRTRANSAXLE RANGE SWITCH LEVER REPLACEMENT
2006 Chevrolet Equinox FWD V6-3.4L VIN F

Transaxle Range Switch Lever Replacement

2006 Chevrolet Equinox FWD V6-3.4L VIN FSECTION Transaxle Range Switch Lever Replacement


Transaxle Range Switch Lever Replacement
^ Tools Required

- J 36346 Fascia Retainer Remover

Removal Procedure
1. Remove the battery tray.





2. Using the Fascia Retainer Remover J 36346, disconnect the shift control cable from the transaxle range switch lever.





3. Remove the transaxle range switch lever nut and lever.

Installation Procedure





Notice: Refer to Fastener Notice in Service Precautions.

1. Install the transaxle range switch lever and lever nut.
^ Tighten the nut to 16 Nm (12 lb ft).





2. Install the shift control cable end fitting onto the ball stud of the transaxle range switch lever. An audible snap will be heard when properly installed.
3. Install the battery tray.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.