Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005TRAILBLAZER 4WD V8-5.3L VIN MREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSAIR FLOW METER/SENSORSERVICE AND REPAIR
2005 Chevrolet TrailBlazer 4WD V8-5.3L VIN M
Air Flow Meter/Sensor: Service and Repair
2005 Chevrolet TrailBlazer 4WD V8-5.3L VIN MSECTION Service and Repair
MASS AIR FLOW (MAF)/INTAKE AIR TEMPERATURE (IAT) SENSOR REPLACEMENT
REMOVAL PROCEDURE
IMPORTANT: Use care when handling the mass air flow/intake air temperature (MAF/IAT) sensor. Do not dent, puncture, or otherwise damage the honey cell located at the air inlet end of the MAF/IAT. Do not touch the sensing elements or allow anything including cleaning solvents and lubricants to come in contact with them. Use a small amount of a non-silicone based lubricant, on the air duct only, to aid in installation.
1. Disconnect the MAF/IAT sensor electrical connector.
2. Loosen the clamps at the MAF/IAT sensor and the throttle body.
3. Remove the air cleaner outlet duct bolt.
4. Remove the air cleaner outlet duct.
5. Loosen the clamp attaching the MAF/IAT sensor to the air cleaner housing.
6. Remove the MAF/IAT sensor from the air cleaner housing.
INSTALLATION PROCEDURE
IMPORTANT: The embossed arrow on the MAF/IAT sensor indicates the proper air flow direction. The arrow must point toward the engine.
1. Locate the air flow direction arrow (2) on the MAF/IAT sensor.
2. Install the MAF/IAT sensor on to the air cleaner housing.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Tighten the clamp securing the MAF/IAT sensor to the air cleaner housing.
Tighten the clamp to 7 N.m (62 lb in).
4. Install the air cleaner outlet duct.
5. Install the air cleaner outlet duct bolt.
Tighten the bolt to 10 N.m (89 lb in).
6. Tighten the clamps at the MAF/IAT sensor and the throttle body.
Tighten the clamps to 7 N.m (62 lb in).
7. Connect the MAF/IAT electrical connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.