Blower Motor Processor Replacement - Auxiliary

2005 Chevrolet TrailBlazer 4WD V8-5.3L VIN MSECTION Blower Motor Processor Replacement - Auxiliary


BLOWER MOTOR PROCESSOR REPLACEMENT - AUXILIARY

REMOVAL PROCEDURE
1. Remove the right rear quarter trim panel.
2. Remove the HVAC module-auxiliary.
3. Disconnect the electrical connector from the blower motor processor.
4. Remove the retaining screws from the blower motor processor (1).




5. Remove the blower motor processor (3) from the HVAC module (2).

INSTALLATION PROCEDURE




1. Install the blower motor processor (3) to the HVAC module (2).
2. Install the retaining screws to the blower motor processor (3).

Tighten the screws to 1.9 N.m (17 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the HVAC module-auxiliary.
4. Connect the electrical connector to the blower motor processor (1).
5. Install the right rear quarter trim panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.