SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005TRAILBLAZER 4WD V8-5.3L VIN MREPAIR AND DIAGNOSISBODY AND FRAMESEATSMEMORY POSITIONING SYSTEMSMEMORY POSITIONING SWITCHSERVICE AND REPAIR
2005 Chevrolet TrailBlazer 4WD V8-5.3L VIN M

Memory Positioning Switch: Service and Repair

2005 Chevrolet TrailBlazer 4WD V8-5.3L VIN MSECTION Service and Repair


MEMORY SEAT SWITCH REPLACEMENT

REMOVAL PROCEDURE




1. Lift up on the front edge of the door lock and side window switch (1) in order to release the front retaining clip.
2. Lift up on the rear edge of the switch panel in order to release the 2 rear retaining clips.




3. Remove the electrical connector (2) from the memory seat switch.
4. Remove the memory seat switch from the lock and door lock and side window switch (1).

INSTALLATION PROCEDURE




1. Position the memory seat switch to the lock and door lock and side window switch (1).
2. Connect the electrical connector (2) to the memory seat switch.




3. Install the door lock and side window switch (1). Verify that the front retaining clips and the rear retaining clips are fully seated.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.