Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005TAHOE 2WD V8-4.8L VIN VREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRHVAC SYSTEM - MANUALHVAC CONTROL MODULE REPLACEMENT
2005 Chevrolet Tahoe 2WD V8-4.8L VIN V
HVAC Control Module Replacement
2005 Chevrolet Tahoe 2WD V8-4.8L VIN VSECTION HVAC Control Module Replacement
HVAC CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the instrument cluster trim plate bezel.
2. Remove the instrument panel storage tray.
3. Remove the accessory switch assembly from the instrument panel.
4. Remove the screws from the HVAC control assembly.
5. Remove the HVAC control assembly, with the following procedure:
1. Release the retaining tabs.
2. Pull the control head out of the instrument panel carrier.
6. Disconnect the electrical connectors from the HVAC control assembly.
INSTALLATION PROCEDURE
1. Connect the electrical connectors to the HVAC control assembly.
IMPORTANT: The Key should be in the off position when connecting the electrical connectors to ensure proper calibration.
2. Install the HVAC control assembly.
3. Install the accessory switch assembly to the instrument panel.
4. Install the screws from the HVAC control assembly.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.9 N.m (17 lb in).
5. Install the instrument panel storage tray.
6. Install the instrument cluster trim plate bezel.
7. Start the vehicle and let run for one minute.
IMPORTANT: Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating.
If interrupted improper HVAC performance will result.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.