Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005SILVERADO SS V8-6.0L VIN NREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSDATA LINK CONNECTORSERVICE AND REPAIR
2005 Chevrolet Silverado SS V8-6.0L VIN N
Data Link Connector: Service and Repair
2005 Chevrolet Silverado SS V8-6.0L VIN NSECTION Service and Repair
DATA LINK CONNECTOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the bolt from the data link connector (DLC).
2. Remove the DLC from the instrument panel (I/P).
INSTALLATION PROCEDURE
1. Install the DLC to the I/P.
2. Install the DLC bolt.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolt to 6 N.m (53 lb in).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.