Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005SILVERADO SS V8-6.0L VIN NREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTTECHNICAL SERVICE BULLETINSSTEERING/SUSPENSION - REVISED ALIGNMENT SPECIFICATIONS
2005 Chevrolet Silverado SS V8-6.0L VIN N
Steering/Suspension - Revised Alignment Specifications
2005 Chevrolet Silverado SS V8-6.0L VIN NSECTION Steering/Suspension - Revised Alignment Specifications
Bulletin No.: 05-03-07-006
Date: May 31, 2005
SERVICE MANUAL UPDATE
Subject:
Revised Wheel Alignment Specifications
Models:
2005 Chevrolet Silverado
2005 GMC Sierra
This bulletin is being issued to revise the Wheel Alignment Specifications in the Wheel Alignment sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.
The information shown has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin on the affected page.
Disclaimer
Date: May 31, 2005
SERVICE MANUAL UPDATE
Subject:
Revised Wheel Alignment Specifications
Models:
2005 Chevrolet Silverado
2005 GMC Sierra
This bulletin is being issued to revise the Wheel Alignment Specifications in the Wheel Alignment sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.
The information shown has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin on the affected page.
Disclaimer
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.