Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005SILVERADO SS V8-6.0L VIN NREPAIR AND DIAGNOSISBODY AND FRAMESEATSMEMORY POSITIONING SYSTEMSMEMORY POSITIONING MODULESERVICE AND REPAIRMEMORY SEAT CONTROL MODULE REPLACEMENT
2005 Chevrolet Silverado SS V8-6.0L VIN N
Memory Seat Control Module Replacement
2005 Chevrolet Silverado SS V8-6.0L VIN NSECTION Memory Seat Control Module Replacement
MEMORY SEAT CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the seat cushion.
2. Disconnect the upper electrical harness connectors (3).
3. Remove the module (2) retaining screws (1).
4. Slide the module to the right to disengage the lower retainers.
5. Disconnect the lower electrical harness connectors (2).
6. Remove the module from the vehicle.
INSTALLATION PROCEDURE
1. Position the module into the vehicle.
2. Connect the lower electrical harness connectors (2).
3. Slide the module (2) to the left to engage the lower retainers.
4. Install the module retaining screws (3).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 3 N.m (26 lb in).
5. Connect the upper electrical harness connectors (3).
6. Install the seat cushion.
7. If a new memory seat module was installed, calibrate the seat. Refer to Memory Seat Calibration Procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.