Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005OPTRA (CANADA) L4-2.0LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSSERVICE AND REPAIRFRONT SIDE DOOR WINDOW REPLACEMENT
2005 Chevrolet Optra (CANADA) L4-2.0L
Front Side Door Window Replacement
2005 Chevrolet Optra (CANADA) L4-2.0LSECTION Front Side Door Window Replacement
Front Side Door Window Replacement
Removal Procedure
1. Remove the door seal trim. Refer to Door Water Deflector Replacement Door Water Deflector Replacement.
2. Remove the center pillar molding. Refer to Center Pillar Applique Replacement Service and Repair in Exterior Trim.
3. Remove the screws that secure the glass to the window regulator.
4. Remove the glass from the door.
Installation Procedure
1. Install the glass in the door and position the glass within the window regulator.
Notice:
Refer to Fastener Notice Fastener Notice in Cautions and Notices.
2. Install the glass to the window regulator with the screws.
Tighten the glass screws to 7 Nm (62 lb in).
3. Install the center pillar molding. Refer to Center Pillar Applique Replacement Service and Repair in Exterior Trim.
4. Install the door seal trim. Refer to Door Water Deflector Replacement Door Water Deflector Replacement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.