Power Steering System Bleeding

Power Steering System Bleeding

Notice:
Refer to Air in the Power Steering System Notice Service Precautions in Cautions and Notices.

1. Turn the wheels all the way to the left and add the power steering fluid to the MIN mark on the fluid level indicator.

Notice:
Refer to Power Steering Required Fluid Notice Service Precautions in Cautions and Notices.

2. Start the engine. With the engine running at fast idle, recheck the fluid level. If necessary, add fluid to bring the level up to the MIN mark.

3. Bleed the system by turning the wheels from side to side without reaching the stop at either end. Keep the fluid level at the MIN mark. The air must be eliminated from the fluid before normal steering action can be obtained.

4. Return the wheels to the center position. Continue running the engine for 2-3 minutes.

5. Road test the vehicle to be sure the steering functions normally and is free from noise.

6. Recheck the fluid level as described in steps 1 and 2. Make sure the fluid level is at the MAX mark after the system has stabilized at its normal operating temperature. Add fluid as needed.