Keyless Entry Receiver: Service and Repair

2005 Chevrolet Optra (CANADA) L4-2.0LSECTION Service and Repair



Remote Control Door Lock Receiver Replacement

Removal Procedure





Caution:
Refer to Battery Disconnect Caution Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.

2. Remove the floor console. Refer to Front Floor Console Replacement Service and Repair in Instrument Panel, Gauges and Console.

3. Disconnect the control module/receiver electrical connector.

4. Slide the control module/receiver away from the mounting bracket.

Installation Procedure





1. Install the control module/receiver on its mounting bracket.

2. Connect the control module/receiver electrical connector.

3. Install the floor console. Refer to Front Floor Console Replacement Service and Repair in Instrument Panel, Gauges and Console.

4. Connect the negative battery cable.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.