Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005MONTE CARLO V6-3.8L VIN KREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - CRUISE CONTROLCRUISE CONTROL MODULESERVICE AND REPAIR
2005 Chevrolet Monte Carlo V6-3.8L VIN K
Cruise Control Module: Service and Repair
2005 Chevrolet Monte Carlo V6-3.8L VIN KSECTION Service and Repair
CRUISE CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
The cruise control module is mounted to the left strut tower and must be serviced as a complete unit.
1. Remove the cruise control cable from the cruise control module.
2. Disconnect the cruise control module electrical connector.
3. Remove the cruise control module shock tower nuts.
4. Remove the cruise control module.
INSTALLATION PROCEDURE
1. Install the cruise control module on the mounting studs located on the shock tower.
2. Install the cruise control module mounting nuts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the cruise control module to shock tower nuts to 2 N.m (18 lb in).
3. Connect the cruise control module electrical connector.
4. Install the cruise control cable to the cruise control module.
IMPORTANT: The cruise control cable does not require mechanical adjusting after the replacement. The cruise control module internally adjusts the cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.