Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005MONTE CARLO V6-3.8L SC VIN 1REPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSSERVICE AND REPAIRWIPER DRIVE SYSTEM MODULE REPLACEMENT
2005 Chevrolet Monte Carlo V6-3.8L SC VIN 1
Wiper Drive System Module Replacement
2005 Chevrolet Monte Carlo V6-3.8L SC VIN 1SECTION Wiper Drive System Module Replacement
WIPER DRIVE SYSTEM MODULE REPLACEMENT
TOOLS REQUIRED
- J 39232 Wiper Transmission Separator
- J 39529 Wiper Transmission Installer
REMOVAL PROCEDURE
1. Remove the air inlet grille panel.
2. Remove the wiper motor water deflector.
3. Using the J 39232, disconnect the wiper transmission from the wiper motor crank arm to aid in the removal of the wiper drive system module.
4. Remove the wiper drive system module screws.
5. Disconnect the wiper motor electrical connector.
6. Remove the wiper drive system module from the vehicle.
INSTALLATION PROCEDURE
1. Position the wiper drive system module to the vehicle.
2. Connect the wiper motor electrical connector.
3. Install the wiper drive system screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 10 N.m (89 lb in).
4. Using the J 39529, Install the wiper transmission to the wiper motor crank arm.
5. Install the wiper motor water deflector.
6. Install the air inlet grille panel.
7. Inspect the wipers for proper operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.