Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005MONTE CARLO V6-3.8L SC VIN 1REPAIR AND DIAGNOSISDIAGRAMSEXPLODED VIEWSAUTOMATIC TRANSMISSION/TRANSAXLESYSTEM DIAGRAMUNIT REPAIRTRANSMISSION TO TRANSFER CASE COMPONENTS
2005 Chevrolet Monte Carlo V6-3.8L SC VIN 1
Transmission to Transfer Case Components
2005 Chevrolet Monte Carlo V6-3.8L SC VIN 1SECTION Transmission to Transfer Case Components
Transmission to Transfer Case Components
3 - Transmission Case
8 - Case Extension Seal
9 - Vehicle Speed Sensor Bolt M8 X 1.25 X 12.0
10 - Vehicle Speed Sensor Assembly
11 - Vehicle Speed Sensor O-Ring Seal
509 - Output Shaft Snap Ring
509 - Output Shaft Snap Ring
510 - Output Shaft
689 - Final Drive Sun Gear Shaft
695 - Parking Gear Thrust Bearing
696 - Parking Gear
697 - Final Drive Sun Gear
901 - Oil Dam
902 - Selective Washer
903 - Brace Bolts
903 - Brace Bolts
904 - Transfer Case Lower Brace Bolt
905 - Side Brace
906 - Lower Brace
907 - Transfer Case to Case Bolts
908 - Transfer Case Assembly
909 - Transfer Case to Case Bolts
910 - Transfer Case to Case Bolts
Transmission to Transfer Case Components:
3 - Transmission Case
8 - Case Extension Seal
9 - Vehicle Speed Sensor Bolt M8 X 1.25 X 12.0
10 - Vehicle Speed Sensor Assembly
11 - Vehicle Speed Sensor O-Ring Seal
509 - Output Shaft Snap Ring
509 - Output Shaft Snap Ring
510 - Output Shaft
689 - Final Drive Sun Gear Shaft
695 - Parking Gear Thrust Bearing
696 - Parking Gear
697 - Final Drive Sun Gear
901 - Oil Dam
902 - Selective Washer
903 - Brace Bolts
903 - Brace Bolts
904 - Transfer Case Lower Brace Bolt
905 - Side Brace
906 - Lower Brace
907 - Transfer Case to Case Bolts
908 - Transfer Case Assembly
909 - Transfer Case to Case Bolts
910 - Transfer Case to Case Bolts
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.