Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005MONTE CARLO V6-3.8L SC VIN 1REPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SERVO CABLESERVICE AND REPAIR
2005 Chevrolet Monte Carlo V6-3.8L SC VIN 1
Cruise Control Servo Cable: Service and Repair
2005 Chevrolet Monte Carlo V6-3.8L SC VIN 1SECTION Service and Repair
CRUISE CONTROL CABLE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the cruise control from the throttle body lever and the accelerator control cable bracket.
2. Remove the cruise control cable from the cruise control cable retainers.
3. Remove the cruise control cable from the cruise control module cable strap.
4. Remove the cruise control cable from the cruise control module by rotating the cruise control cable counterclockwise.
5. Remove the cruise control cable.
INSTALLATION PROCEDURE
1. Position the cruise control cable to the engine.
2. Install the cruise control cable to the module by rotating the cruise control cable clockwise.
3. Install the cruise control cable to the cruise control cable retainers.
4. Install the cruise control cable to the cruise control module cable strap.
IMPORTANT:
- Ensure the module strap is not twisted during installation of the cable.
- The cruise control cable does not require mechanical adjusting after the replacement. The cruise control module internally adjusts the cable.
5. Install the cruise control cable to the throttle body lever and the accelerator control cable bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.