Vehicle Speed Sensor (VSS) Replacement - Input

2005 Chevrolet Express 1500 RWD V6-4.3L VIN XSECTION Vehicle Speed Sensor (VSS) Replacement - Input


Vehicle Speed Sensor (VSS) Replacement - Input
Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Disconnect the input speed sensor (1) electrical connector.
3. Remove the input speed sensor bolt.
4. Remove the input speed sensor (1) and the bracket assembly from the case.
5. Inspect the vehicle speed sensor assembly (1) for any evidence of damage.

Installation Procedure





1. Lubricate the input speed sensor seal with automatic transmission fluid.
2. Install the input speed sensor (1) and the bracket assembly.

3. Notice: Refer to Fastener Notice in Service Precautions.

Install the bolt.
^ Tighten the bolt to 11 Nm (96 inch lbs.).
4. Connect the input speed sensor electrical connector.
5. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.