Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005EXPRESS 1500 RWD V6-4.3L VIN XREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCOOLANT TEMPERATURE SENSOR/SWITCH (FOR COMPUTER)SERVICE AND REPAIR
2005 Chevrolet Express 1500 RWD V6-4.3L VIN X
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
2005 Chevrolet Express 1500 RWD V6-4.3L VIN XSECTION Service and Repair
ENGINE COOLANT TEMPERATURE (ECT) SENSOR REPLACEMENT
REMOVAL PROCEDURE
NOTE: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
1. Turn OFF the ignition.
2. Remove the engine cover.
3. Drain the coolant below the level of the ECT sensor. Refer to Draining and Filling Cooling System in Cooling System.
4. Disconnect the electrical connector.
5. Carefully remove the ECT sensor.
INSTALLATION PROCEDURE
NOTE: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
1. Coat the threads with sealer GM P/N 9985253 or equivalent.
2. Install the ECT sensor.
NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.
Tighten the ECT sensor to 20 N.m (15 lb ft).
3. Connect the ECT sensor harness connector to the ECT sensor.
4. Refill the cooling system. Refer to Draining and Filling Cooling System in Cooling System.
5. Install the engine cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.