Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005EQUINOX FWD V6-3.4L VIN FREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIRPOWER WINDOW SWITCH REPLACEMENT
2005 Chevrolet Equinox FWD V6-3.4L VIN F
Power Window Switch Replacement
2005 Chevrolet Equinox FWD V6-3.4L VIN FSECTION Power Window Switch Replacement
Power Window Switch Replacement
Removal Procedure
1. Remove the console shift lever bezel. Refer to Trim Bezel Replacement - Center (Instrument Panel (IP) - Trim Bezel Replacement - Center) in Instrument Panel, Gages, and Console.
2. Remove the screws from the power window switch assembly.
3. Remove the switch assembly from the bezel.
Installation Procedure
1. Position the switch assembly.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the screws to the switch assembly.
Tighten the screws to 2.5 Nm (22 lb in).
3. Install the console shift lever bezel. Refer to Trim Bezel Replacement - Center (Instrument Panel (IP) - Trim Bezel Replacement - Center) in Instrument Panel, Gages, and Console.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.